OD multi-task milling
¡¡¡¡
Characteristic of cutter£º
1¡¢ Double positive front angle, light and fast cutting
2¡¢ Economic: 8 cutting edges
3¡¢ Wide range of application: P, K, M, S and N material
4¡¢ Nickel-plated cutter, good look, anti-corrosion and wear resistible
5¡¢ Diameter of cutter from 40 to 160, diameter less than 125 with internal coolant
6¡¢ OD04 and OD06, two types of inserts to choose
Characteristic of inserts£º
Positive, eight cutting edges on one side, very economic
Sharp edge, light and fast cutting
Widely applied in face milling for roughing, semi-finishing and finishing steel and cast iron.
Geometry introduction:
HR2 is stable
Can be applied in difficult cutting condition
Stable in machining
High feed rate
MM3 is easy to cut
Can be applied in good condition for semi-finishing and finishing
Low cutting force
Medium feed rate
FM2 is sharp
Designated for machining aluminum
Low cutting force
Sharp cutting edge